Gap Settings at Startup & Roll Re-Alignment

Your mill is equipped with roll adjustment points.

These are located on the front of the machine – see image below.

Setting and keeping the roll gaps is essential to target your desired grind. Keeping rolls in parallel is essential for proper wear on the rolls and consistent output.

For additional information on the following sections, see Page 9.1 for Feed Mills and large Brewery mills. See Page 9.2 for the MicroMill and 6x6 mills.

SECTION I: Starting up the mill

SECTION II: Zeroing the Rolls

SECTION III: Paralleling the Rolls

Stickers like this can be found on the adjustment points of your mill.